Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Repair Before & After in Garden Grove, CA
Most gate companies tell you they do good work. We’d rather show you. The photo log we leave on every job isn’t just paperwork, it’s the record of what we found, what we touched, and what it looked like when we left. These are the kinds of repairs we handle on Garden Grove properties every week: sagging gates, dead motors, broken welds, and automation that stopped behaving. Written price first, photos after, every time.
Recent Transformations
Sagging Steel Driveway Gate: Hinge Replacement & Realignment
The problem: a 14-foot steel driveway gate had dropped roughly two inches at the latch side. The bottom hinge had been shimmed with washers by a previous repair, which bought time but chewed the hinge barrel. We replaced both hinges with heavier-rated weld-on barrels, lifted the gate back to level, and set the latch post plumb. The gate now swings with one hand and the latch engages without lifting the handle.
Dead Swing Gate Motor: LiftMaster Replacement & Limit Reset
The problem: a LiftMaster swing motor had stopped responding entirely. The limit switch was set 12 degrees past travel, which had been overworking the gearbox for months before it seized. We installed a new motor, reset both limits to the actual gate travel, and realigned the photo-eye beam, which was off by roughly two inches. The gate now opens and closes in about 14 seconds, and the homeowner has a photo log of every setting change.
Broken Weld on Ornamental Iron Gate: Repair & Reinforcement
The problem: a cracked weld where the top rail met the hinge stile had let the gate flex every time it opened. Each cycle widened the crack and stressed the remaining pickets. We ground out the old weld, rewelded the joint, and added a small gusset plate to spread the load. The gate no longer twists on the hinge side, and the repair is painted to match the original finish.
Access Control Keypad Failing at Night: Wiring & Component Repair
The problem: a DoorKing keypad worked during the day but failed most evenings. We found corroded wire splices inside the pedestal, the kind that expand and contract with temperature shifts. We replaced the relay, stripped back the corroded wire, and made weather-sealed connections. The keypad now responds consistently, and we photographed every splice before closing the pedestal.
Chain-Link Rolling Gate Off Track: Roller & Track Repair
The problem: a rolling chain-link gate had jumped its track and was leaning hard against the fence line. The lower roller assemblies were worn flat on one side, and the track had shifted where a vehicle had clipped the curb. We replaced both roller assemblies, adjusted the track back into position, and cleaned years of debris out of the guide channel. The gate rolls without dragging, and the homeowner was shown exactly which parts were replaced.
Mighty Mule Operator Beeping but Not Moving: Arm Bracket & Limit Fix
The problem: a Mighty Mule operator was powering on and beeping but not moving the gate. The arm bracket had sheared at the mounting point, so the motor was spinning against nothing, and the travel limit was still set from a previous, shorter gate. We fabricated a reinforced bracket, bolted it through the gate frame, and reset the operator travel limits. The gate cycles smoothly, and the repair is covered under the 365-Day Done Right Promise.
Want Results Like These?
If your gate sags, sticks, or the motor beeps without moving, we’ll put the problem in writing before we touch it: the part, the price, and the plan. Every job ends with a photo record and a one-year promise that the fix stays fixed. Call (657) 837-6867 and a live person will answer, day or night.
Written by Adrian Vance, Owner at Vance Gate Repair Garden Grove, serving Garden Grove since 2014.